This is AVRISP/USBasp/STK500 10PIN to 6PIN Standard Conversion Stand BTE13-006 from the category Sensors | Serial/Converter.Conversion Stand, a productColor:blackType:STK500 10PIN to 6PIN, USBasp, AVRISPUse: to download, burn, and test using the normal ATMEL isp6 port instead of the standard ATMEL i..
This is CC2531/CC2540 Sniffer USB dongle Analyzer Module from the category Sensors | Serial/Converter.Software for support includes SmartRF Studio, SmartRF Flash Programmer, IEEE Address Programmer, PacketSniffer, PurePathWireless, and IAR for 8051 (including version 8.10 used by the most recent Z-s..
This is CH340 USB to ESP8266 ESP-01 ESP-01S Wifi Adapter Board from the category Sensors | Serial/Converter.Working voltage: 4.5 to 5.5 volts (On-board 3.3v LDO Regulator)300 mA, working current (LDO regulator can supply)On-board toggle switch with two working modes: PROG for firmware programming an..
This is CH341A USB To UART IIC SPI TTL ISP EPP Parallel Converter from the category Sensors | Serial/Converter.Descriptions:Support for parallel ports includes EPP or EME parallel ports as well as parallel ports for USB to printers.Support for serial ports: UART, I2C, and SPI interfaces on USBOutput..
This is CJMCU CP2102 USB To TTL Serial Module from the category Sensors | Serial/Converter.Upon driver installation, the original chip, CP2102, generates a COM port.2. The computers USB interface was then linked using the standard input MICRO MINI-USB cable, which has two power outputs of 3.3V and 5..
This is CP2102 USB 2.0 To TTL UART Connector Module from the category Sensors | Serial/Converter.1. After installing a driver, the primary chip, CP2102, creates a virtual serial port.2. USB power, signal pin level is 3.3V, positive logic, GND, TX, Rx, 3.3V ( 40mA), and lead out interface.3. After th..
This is DB9 RS232 RS485 Serial to Terminal dapter Connector Breakout Board from the category Sensors | Serial/Converter.1.RS232 D-Sub 9-pin connectors with standard density and tin plating.2. Commercial DB9 female and male solder cup connectors that are industry standard.3.A connection insulator wit..
This is DIY ESP-32S Adapter Plate ESP8266 Serial WiFi Module Expansion Board from the category Sensors | Serial/Converter.0Note: Import Dukan Purchase Directly From Manufacturer and Deliver to you without any extra charge hence We are able to provide Lowest rate and Standard Quality...
This is ESP-01 ESP-01S Adapter Plate Breadboard Adapter ESP8266 from the category Sensors | Serial/Converter.This esp-01 breadboard adapter is a typical model for the esp8266 serial to WiFi transceiver module.The esp-01s pin configuration is not suitable for quick prototyping because it is not bread..
This is ESP8266 ESP-01/01S DS18B20 Temperature Sensor WiFi Adapter Module from the category Sensors | Serial/Converter.Characteristic:Master: ESP-01/ESP-01S (ESP-01/ESP-01S are not included in this module)DS18B20 temperature sensorDC 3.7V–12V is the operating voltage (support 3.7v lithium battery po..
This is FT232RL USB To TTL Serial IC Adapter Convert Module from the category Sensors | Serial/Converter.1. Pounds: 5g2. Completely new and premium quality3. Backing 3.3V, 5VChipset: FT232RL 4.5. USB power uses a 500MA self-restore fuse for excessive current safety.6. Communication RXD/TXD transceiv..
This is GY-9833 AD9833 DDS Module from the category Sensors | Serial/Converter.power supply from 2.3 to 5.5 voltsSPI interface line without requiring any extra componentsRange of temperatures: 40 °C to + 105 °Cpower-off choiceupdating every 25 (maximum)Maximum VOUT: 0.65 V.VOUT minimum: 38 mVTempera..