DC 12V 24V PWM Stepper Motor Pulse Signal Generator | Modules | Program/Driver

This is DC 12V 24V PWM Stepper Motor Pulse Signal Generator from the category Modules | Program/Driver.

Description 1. This module generates pulses and provides the control signal to the stepper driver.

The stepper motor needs to have a drive in order to be controlled.

2. A straightforward set of control platforms can be created using this straightforward controller, a stepper motor, a stepper motor, and a DC power source.

3. The controller contains three types of low frequency signals that can be used to pick the jumper: high (5.4k-160khz), middle (540-16.6khz), and low (80-2.4khz).

4.Can generate pulse or PWM signals; jumper selection available.

5. The frequency of the PUL and common cathode end measurements

Various stepper drivers may leave various name markings.

EN=ENA=FREE Enable Pulse DIR=CW=CWW and PUL=PULS=CLK Direction

EN+ PUL+ DIR+ link to com+ as part of the common anode connection technique (B).

connect in EN link EN PUL DIR CLK