3Drobotics 433Mhz V1 500Mw Telemetry Kit

This is 3Drobotics 433Mhz V1 500Mw Telemetry Kit From The category RC Drone Accessories for Flight Controller. You can connect a flight controller to a USB or UART-equipped device, such as a computer, laptop, or tablet supporting a USB connection, using this 3DR Radio Telemetry 433MHz 500mW Set (OTG).

Specifications:

• Status documents for the MAVLink protocol
• Spread Spectrum and frequency modulation (FHSS)
• Adaptation by oneself to time division multiplexing
• Encourage LBT and AFA
• adjustable duty cycle
• Error-correcting code built-in (up to 25% data bit error)
• Configure data transport using AT commands
• remote control data transmission with the RT command
• movable 433MHz air and ground modules
• USB 2.0 port
• maximum output power of 250mW from a 6-position Molex connector (adjustable)
• 2-way full-duplex communication over an adaptive TDM UART interface using a SMA connector
• a clear serial link
• downloadable SIK firmware
• Through the use of *Mission Planner and *APM Planner, configure
• With a Si1000 8051 microprocessor and a Si4432, based on the HM-TRP wireless module

Note: Import Dukan Will Import Your Product Directly From Manufacturer and Deliver to you without any extra charge of custom clearance or shipping. We are directly purchasing and delivering to you hence We are able to provide Lowest rate and Standard Quality.